1. Fine car washing removes dirt from the car body. For the parts to be constructed, clean them repeatedly with cleaning liquid to remove all dust and sand.
2. Remove chromium-plated parts of the original vehicle;
3. Remove body parts;
4. Wipe the body with alcohol to remove grease and dirt.
5. Measuring the length of the body panel, according to the construction of the body structure in blocks, when the transparent film needs to be repainted in the future, it is also simple to operate and reduce the cost of owner's capital.
6. Mould cutting construction, multi-technicians to coordinate construction, tacit cooperation to create a successful construction;
7. After cleaning, use wet sticking film, take out the cut sticking film, tear off the back paper of the film, pay attention to wetting the hand first, try not to touch the back paper, because it will leave difficult to remove fingerprints, wet hand tear off the back paper, immediately spray the film and car paint with alcohol solution (film-pasting liquid) equally. When the greatest smoothness is reached, the next overlay construction will be carried out. The body radian will be roasted out, and the scraper will clean up the water, so that the transparent film will adhere tightly to the body.
8. Large surface construction is relatively simple, and edge sealing is very important. First of all, the redundant edges should be cut off. When cutting the film, it should be done at once, so as to prevent the occurrence of repeated cutting, and the edges of the cut film are uneven.
9. When the transparent film of the car body is pasted on the car body to consolidate, the grill and grab, 3M glue are separated satisfactorily, and the chrome-plated parts of the car body are restored!
10. Tear off the body film and show the body well.
11. Exposure to the sun and moisture, and the construction is over.
This article is written by Jinan Automobile Invisible Vehicle Clothes. For more products and more details, please pay attention to our official website: http://www.hhgted.com.